5 Common Problems with John Deere X584 (Solutions Included)

If you’re in the market for a new mower that can handle all your yard throws at it, the John Deere X584 might be the ideal piece of equipment for the job. This mower offers a consistent cut every time thanks to its four-wheel steering and the Accel DeepTM Mower Deck that comes included.

Using John Deere X584, you may face some problems such as the engine not working, power loss, engine overheating, etc.

However, these problems are not very difficult to solve. And you can do them with the help of some mower repairing tools. 

First, you will find the exact issue, then you can fix it easily as I have shared details of the fixing in this article.

Problems and Solutions at a Glance:

Problems with John Deere X584Solutions
Engine not startingClean filters, put quality oil, change spark plugs
Engine overheatingRest during work, clean air filter, change it
Power lossKeep mowing speed low, change pump
Starter motor will not turn engineChange the fuse
Excessive tractor vibrationChange belt

5 Most Common Problems with John Deere X584 and Their Possible Solutions:

It’s possible that the John Deere 5045e will experience issues due to a wide range of different factors.

The following is a list of some of the problems, as well as potential fixes to those issues and the causes of those problems.

1. Engine Not Starting

In your John Deere x584, there can be a small issue of the engine not being able to start. This can be caused by several reasons.

If you have no oil in the tank, your mower will not start. It can also happen if the oil grade is not matched or you have old oil in the tank.

One of the many other reasons why the engine does not start can be due to spark plug defects or damage.

When you have a faulty safety switch it may stop you from starting the engine as well. In case your filter is clogged, the engine may not start or struggle to start.

The Fix:

First of all, you need to find the exact reasons behind the problem. After you find the problem, you can now fix it. Here are some solutions to some specific problems.

  • If you check the oil tank and see that there is no oil left, then this is the easiest problem, and all you are to fill up the tank with proper oil.
  • If the main issue is the wrong oil grade, then all you have to do is empty the tank of the previous oil and fill it up with the correct grade oil.
  • When your mower’s spark plugs are damaged or have some kind of defects, you should change them. Because it will be a hassle to repair it. And in most cases, it does not work properly even if you can repair it.
  • If you check the safety switch and see it is damaged then you should replace it with a new one.
  • When the filter is clogged, the engine will struggle to start. So, regular cleaning is necessary to prevent it from happening.

2. Engine Overheating

There are five possible reasons behind engine overheating.

  1. Engine overloaded
  2. The air intake screen clogged
  3. Engine oil high or too low
  4. Poor quality oil
  5. Idle speed problems

When the mower is run for several hours without a break it can cause overload and create heating issues.

Also, if the air intake screen is blocked somehow, it can’t pass the heat outside and lead to overheating. There can be other reasons for this problem.

The Fix:

Overheating issue does not need heavy fixes. What you need to do is check the air filter and look for anything jamming it.

If you find anything, clean it and make sure the air is getting out easily. Always put good quality oil for running your mower.

If you want to use the mower for long period, then make sure you are giving it a rest every 30-40 minutes. It will keep the engine to release the heat and cool down.

3. Power Loss

If you are mowing different types of grass; if dirt is building up beneath the mower deck; if there is a restriction in the flow of air and fuel; or if the engine oil level is low, a lawn mower will experience a loss in power.

Whenever the engine of the lawn mower is subjected to an excessive amount of load, it is possible for it to experience a loss of power.

When there is an excessive amount of load on the mower, it means that the operator is expecting the mower to work more than it normally would since they are working in more difficult conditions.

A dirty carburetor, bad fuel, or plugged air filter can also cause power loss. Even when the engine dies it can cause a sudden power loss.

The Fix:

Power loss problems can be fixed if you put some effort into fixing them. John Deere x584 can already handle heavy work.

But remember it can also break down if you speed it up and try to cut grass that is wet, tall, and thick grass. Thus, keep your speed low to avoid this problem.

Clean the air filter regularly to avoid jamming it. If the fuel pump is bad, you should change it as well.

4. The Starter Motor will Not Turn the Engine

John Deere x584 sometimes showed issues regarding the starter motor. Sometimes it did not work as few users reported. A defective fuse is one of the reasons for this problem.

If you have this problem, you should also check battery terminals if they are corroded. When the battery is discharged completely this problem also occurs in the x584 mower.

An ignition switch problem or damaged starter can also be the cause of the starter issue. If nothing seems to be wrong, then check the wiring.

The Fix:

First of all, check and change the defective fuse. If the fuse is not a bad move on to the next part.

Check for any anomalies in battery terminals. If it is corroded, clean it properly and it should solve the problem by clearing the electricity flow.

In case, the battery is completely discharged, recharge it. If you see that, not one of them is causing the issue, it must be the switch. Either the ignition switch or the starter is damaged. Inspect and change it.

5. Excessive Tractor Vibration

The vibration issue of x584 is mainly caused by a damaged traction drive belt.

If it gets worn out it can cause excessive vibration. Dirt on the driven pulley can be behind this kind of irregular vibration as well.

The Fix:

The solution to this problem is very straightforward. You have to detach the belt from the mower. Buy a new belt and put it back in. And always keep your driven pully clean.

What Majority of the Users Feel about John Deere X584?

The John Deere x584 is an excellent mower, but it has the potential to experience a few minor problems. Despite this, it has received a fantastic rating from the general public: 4.3 out of 5 stars!

People commented on the mower based on their experiences. Some said there have been no problems after 2-3 years of use. They loved the power steering, 4-wheel steer, and the ride. It is easy to use.

This mower gives them a stylish appearance while they cut the grass and makes it easy for them to ride.

Although it was pricey, it has more than paid for itself not just in terms of time savings but also in terms of labor savings! 

Frequently Asked Questions

Does the John Deere X584 have power steering?

The John Deere X584 has a standard hydraulic power steering which is easy to move and easy to use.

Why does my John Deere X584 mower keep cutting off?

Whenever the engine of a John Deere x584 mower is deprived of air or fuel because of dirty filters, blocked fuel lines, contaminated fuel, it is possible for the mower to start, but then it will immediately shut off.

Final Thoughts

There is no doubt that the John Deere x584 is an amazing mower with so many features and convenience. However, you can come across some minor issues while riding the mower.

If you have read this article, you should know what causes the John Deere x584 problems and how you can fix them easily.

Related Posts: